KUT EPOXY ANCHOR

Description

KUT EPOXY ANCHOR is available in two grades, “NS” and “P”. Both grades are three-component products consisting of Base, Hardener, and Filler supplied in pre-measured quantities ready for mixing and use. After hardening, the anchorages give consistent reproducible values. Both grades of KUT EPOXY ANCHOR can be used for all anchoring applications, having proper dimensions of hole diameters and bolt sizes and types. KUT EPOXYANCHOR “NS” is a “non-sag” material and is used in overhead or horizontal holes. The thixotropic nature reduces the flow of grout out of the hole. KUT EPOXY ANCHOR “P” is a “Pourable” material and is used in holes made on horizontal surfaces.

Uses

High strength corrosion resistant anchoring of bolts and bars from 12-51 mm diameter into concrete, rock, masonry, or brickwork where high speed of installation and early application of load is required. Permanent installation of reinforcement starter bars, foundation bolts, base plates, balustrading, barriers, safety fences, tracks, tie-back anchors, reinforcement dowelling abutments, and ground anchors for towers, cranes, and dock sills.