BONDING & CLEANING AGENTS

Description

KUT SEGBOND 2550 is a specially formulated non–shrink, non-sag, solvent-free epoxy resin-based Adhesive blended with fine inert fillers. It is supplied as a two-component material in pre-weighed quantities ready for onsite mixing and use. KUT SEGBOND 2550 has been specially formulated where the Ambient temperature is varying from 25ºC to 50ºC. A fast-setting grade KUT SEGBOND 0525 for Ambient temperature at the site from 5ºC to 25ºC is also available.

Uses

KUT SEGBOND 2550 is primarily intended as an adhesive for segmental bonding of match cast and precast concrete segments, and precast concrete bridge segments to provide structural and waterproof joints. suitable as a gap-filling paste and for grouting of starter bars, holding down bolts, etc. where thixotropic consistency is required.

Description

KUT TILE ADHESIVE LM is supplied as a ready to use Two component product to produce a cohesive, sticky highly adhesive thin bed tile fixing mortar. KUT TILE ADHESIVE LM powder is a blend of grey or white cement, micro silica, selected fine sands, water-reducing chemicals in dry powder form, water retention agents, and specially selected chemicals to enhance workability and application ease.

Uses

KUT TILE ADHESIVE LM grey is recommended for the following application:(i) Fixing ceramic tiles on walls and floors. (ii) Bonding quarry tiles direct on concrete or sand cement renderings and clean non-glazed old terrazzo tiles. (iii) Fixing tiles over timber and existing vinyl tiles if the surfaces are properly cleaned and primed with a brush coat of KUT FLEXIBOND. (iv) Fixing mosaic, slip brick, natural stones, and artificial stone tiles. Both grades of KUT TILE ADHESIVE LM are suitable for interior as well as exterior conditions.

Description

KUT TILE MORTAR is supplied as a ready-to-use one-component grey or white powder requiring only the addition of water to produce a cohesive, sticky highly adhesive-thin bed tile fixing mortar. KUT TILE MORTAR powder is a blend of grey or white cement, micro silica, selected fine sands, water-reducing chemicals, the special acrylic polymer in dry powder form, water retention agents, and specially selected chemicals to enhance workability and application ease.

Uses

KUT TILE MORTAR – GREY is recommended for the following application:(i) Fixing ceramic tiles on walls and floors. (ii) Bonding quarry tiles direct on concrete or sand cement renderings and clean non-glazed old terrazzo tiles. (iii) Fixing tiles over timber and existing vinyl tiles if the surfaces are properly cleaned and primed with a brush coat of KUT FLEXIBOND. (iv) Fixing mosaic, slip brick, natural stones, and artificial stone tiles. KUT TILE MORTAR - WHITE is especially recommended for use in marble cladding and other porous and white-coloured tiles. However due care should be taken to ensure proper levels and that the thickness in the such application does not exceed 12mm. Both grades of KUT TILE MORTAR are suitable for interior as well as exterior conditions.